Scientific Temper

Nuclear technology

Nuclear fission, chain reaction and nuclear fuels

Builds on: Nuclear fundamentals (the nucleus as a store of energy).

In a nutshell

Nuclear fission is the splitting of a heavy nucleus such as U-235 after it absorbs a neutron. It releases a large amount of energy and two or three new neutrons, which can split further nuclei in a chain reaction. A reactor keeps this chain reaction steady (critical); a weapon lets it grow without check.

  1. Fissile materials sustain a chain reaction: U-235, Pu-239, U-233.
  2. Fertile materials cannot, but become fissile on absorbing neutrons: U-238 → Pu-239; Th-232 → U-233.

NeutronU-235Energy + 2–3 neutronsMore fissions

"PFBR at Kalpakkam attains first criticality" (April 2026) · "RAPP-8 begins fuel loading" (September 2026)

What exactly became "critical"? To read these headlines you need three ideas: fission, the chain reaction and fissile fuel.

Nuclear fission: extracting energy from the nucleus

We have seen that the nucleus is a store of energy. One way of releasing it is to split the nucleus of certain heavy atoms. This is called nuclear fission.

Consider uranium-235. When a U-235 nucleus absorbs a neutron, it may become unstable and split into two smaller nuclei. In the process it releases:

  • a large amount of energy, mainly as the motion of the fragments, which ends up as heat; and
  • additional neutrons, usually two or three.

It is these additional neutrons that make a continuous supply of energy possible.

Chain reaction

Suppose a neutron causes one U-235 nucleus to split. The neutrons it releases can strike other U-235 nuclei and cause further fissions, and each of those releases more neutrons. This continuing process is a nuclear chain reaction.

U-235 U-235U-235U-235 … 1 fission 3 fissions 6 … Each fission gives • energy (heat) • 2–3 new neutrons Not every neutron splits a nucleus: some escape or are absorbed
A chain reaction. Left unchecked, the number of fissions multiplies in each generation; a reactor removes enough neutrons to keep it steady.

However, not every neutron causes another fission. Some escape from the fuel, and others are absorbed without causing fission. For a steady chain reaction, the number of fissions must stay roughly constant from one generation to the next. This condition is called criticality.

ConditionWhat happens to the chain reactionWhere you meet it
SubcriticalDeclines and dies outA reactor being shut down
CriticalStays steadyA reactor in normal operation
SupercriticalGrowsBriefly, when a reactor raises power; without limit, in a weapon

When a news report says a reactor has "attained first criticality", it means a controlled, self-sustaining chain reaction has been established for the first time. It does not mean the reactor is at full power or supplying electricity.

The minimum mass of fissile material needed to sustain a chain reaction under specified conditions is the critical mass. It depends on the material, its shape and arrangement, and how many neutrons are lost. It is not the same as the percentage of U-235 in uranium, although more highly enriched material needs a smaller critical mass.

Controlled chain reaction

A power plant needs a continuous and controlled supply of heat, so the chain reaction must be regulated. Control rods, made of neutron-absorbing materials such as boron or cadmium, are moved into or out of the core to slow down or speed up the rate of fission, and dropped in fully to shut the reactor down.

This is the essential difference between a reactor and a nuclear weapon. A reactor holds the chain reaction at the level needed to produce heat steadily. In a weapon, a rapidly growing chain reaction releases enormous energy in a very short time.

Nuclear fuels: fissile and fertile materials

Not all nuclei are equally suitable for sustaining fission.

  • Fissile materials can sustain a chain reaction using slow neutrons. The three important ones are U-235, Pu-239 and U-233. Only U-235 occurs in nature in usable quantity; the other two are made in reactors.
  • Fertile materials cannot sustain a chain reaction with slow neutrons, but they turn into fissile materials when they absorb neutrons. The two important ones are U-238 and Th-232.
U-238fertile absorbs a neutron, then two quick decays Pu-239fissile Th-232fertile absorbs a neutron, then two quick decays U-233fissile
Breeding: how fertile materials become fissile fuel inside a reactor.
FissileFertile
U-235 (about 0.7% of natural uranium)U-238 (about 99.3% of natural uranium)
Pu-239 (made from U-238)Th-232 (natural thorium, in monazite)
U-233 (made from Th-232)—
Can sustain a chain reaction under suitable conditionsCan be used to produce additional fissile fuel

This conversion is the principle behind breeding nuclear fuel. It matters greatly for India, because the three-stage programme (see The three-stage programme) uses plutonium, and eventually thorium, to multiply the country's limited supply of fissile material. The fissile material formed in spent fuel is separated by chemical reprocessing.

The three fissile materials compared

The three fissile materials do the same basic job, sustaining a chain reaction, but they come from different places and suit different reactors. This is why each belongs to a different stage of India's programme.

FeatureU-235Pu-239U-233
OriginNatural: about 0.7% of natural uraniumMade in reactors from U-238Made in reactors from thorium (Th-232)
How it is obtainedUsed as natural uranium, or concentrated by enrichmentSeparated from spent fuel by reprocessingSeparated from irradiated thorium by reprocessing
Breeds best inNot used for breeding; burnt mainly in slow-neutron (thermal) reactorsFast reactors: with fast neutrons each fission gives enough spare neutrons to breed more fuel. It also burns in slow-neutron reactors (it forms and fissions inside PHWRs)Slow-neutron reactors: gives more spare neutrons per fission than Pu-239, which makes thorium breeding possible
Half-lifeAbout 704 million yearsAbout 24,000 yearsAbout 1.6 lakh years
Handling issuesWeapons need enrichment to about 90%Highly toxic if inhaled; separated plutonium is a proliferation concernComes mixed with traces of U-232, whose decay products give off strong gamma rays: fuel must be handled remotely behind shielding
Role in IndiaStage 1: PHWRs on natural uraniumStage 2: MOX fuel in the FBTR and PFBRStage 3: KAMINI research reactor now; AHWR and thorium reactors later

All three can in principle be used in weapons, which is why all three are covered by international safeguards and export controls (see International regulation).

Natural uranium and enriched uranium

Natural uranium is about 0.7% U-235 and 99.3% U-238. With so little fissile material, a sustained chain reaction depends on how efficiently neutrons are used.

In most reactors, slow neutrons are much more likely than fast ones to split U-235. The neutrons released in fission are fast, so a moderator is used to slow them down. A good moderator is made of light nuclei: just as a billiard ball loses much of its speed when it strikes another ball of similar mass, a neutron loses much of its energy in each collision with a light nucleus.

  • Heavy water slows neutrons while absorbing very few of them. This allows reactors such as India's PHWRs to run on natural uranium.
  • Ordinary (light) water is cheaper but absorbs more neutrons. Reactors using it make up for the loss by raising the proportion of U-235 in the fuel. This is uranium enrichment.
Natural uranium reactorEnriched uranium reactor
Uses uranium with about 0.7% U-235Uses uranium with a raised share of U-235
Needs efficient use of neutrons, hence heavy waterEnrichment makes up for neutrons lost to light water
Example: Indian PHWRExample: PWR and BWR

How far uranium is enriched depends on its use:

GradeU-235 shareTypical use
Natural uraniumAbout 0.7%Heavy water reactors (PHWRs)
Low-enriched uranium (LEU)Below 20%; usually 3–5% for powerLight water reactors (PWR, BWR)
High-assay LEU (HALEU)Above 5% but below 20%Several advanced reactor and fuel designs, such as ANEEL (see The three-stage programme)
Highly enriched uranium (HEU)20% or more; weapons about 90%Some research and naval reactors; weapons

Why the choice of fuel matters

Three ideas carry into the next lecture. Fission releases energy and neutrons, which allows a chain reaction. The fuel, and how efficiently its neutrons are used, decide what a reactor needs to sustain fission. And fertile materials can be converted into more fissile fuel. Every reactor design is a particular combination of these choices.

Recent developments

No dated updates for this topic yet.

Last-month notes
  • Fissile: U-235 (only natural one, about 0.7%), Pu-239, U-233. Fertile: U-238 → Pu-239; Th-232 → U-233.
  • Fissile compared: U-235 natural, for thermal reactors (stage 1); Pu-239 from U-238, breeds best in fast reactors (stage 2); U-233 from thorium, best in thermal reactors for thorium breeding (stage 3); U-233 fuel is hard to handle because of gamma-emitting U-232.
  • Criticality: steady, self-sustaining chain reaction. Subcritical declines; supercritical grows.
  • Enrichment: natural 0.7%; LEU under 20% (power reactors 3–5%); HALEU 5–20%; HEU 20% or more; weapons about 90%.
  • Moderator slows neutrons (heavy water, light water, graphite). Control rods absorb them (boron, cadmium).

Statements to watch for

  • "First criticality" is not full power, grid supply or commercial operation.
  • Critical mass is a quantity of material, not the enrichment percentage.
  • Heavy water lets a reactor run on natural uranium; light water reactors need enriched fuel.
  • The moderator's job is slowing neutrons; absorbing them to control the reaction is the control rods' job.

Revise and apply

Activities to check your understanding, not new content. Answer first, then press Check or Show answers. Multiple-choice questions are original, in the UPSC style, not past UPSC questions. A printable workbook with all activities is on the theme page.

Complete the mind map

Type the missing words, then check.

Fission and fuels
Fission
A neutron splits a nucleus
Releases energy and
new neutrons
Chain reaction
Steady state:
Minimum fuel: critical
Fuels
Fissile: U-235, ,
Fertile: ,
Control
Moderator neutrons
Control rods them
Enrichment
Power reactors: %
HALEU: %
Weapons: about %
Fill in the blanks
  1. A reactor in steady operation is ; one whose chain reaction is dying out is .
  2. Pu-239 is made from and U-233 from .
  3. Fissile material is separated from spent fuel by .
  4. Light water reactors need fuel because light water absorbs more neutrons.
  5. U-233 fuel is hard to handle because it contains traces of .
Sort it

Sort each material as fissile or fertile.

  1. U-235
  2. U-238
  3. Pu-239
  4. Th-232
  5. U-233
True or false? Correct the false ones
  1. Critical mass is the minimum percentage of U-235 a fuel must contain.
  2. U-235 is the only fissile material found in nature in usable quantity.
  3. A moderator's job is to absorb neutrons and stop the reaction.
  4. HALEU is uranium enriched to more than 20%.
Decode the headline

"RAPP-8 begins fuel loading; first criticality next." (a) What fuel is loaded, and why does it need no enrichment? (b) What will "first criticality" mean? (c) What comes after it?

UPSC-style question 1

Consider the following statements:

  1. A nuclear reactor is said to be critical when its chain reaction is steady, with the number of fissions roughly constant from one generation to the next.
  2. The critical mass of uranium is the minimum percentage of U-235 it must contain to be used as reactor fuel.
  3. Control rods regulate a reactor by absorbing neutrons.

Which of the statements given above is/are correct?

UPSC-style question 2

Which of the following is/are fertile materials?

  1. Uranium-238
  2. Thorium-232
  3. Plutonium-239
UPSC-style question 3

India's pressurised heavy water reactors can use natural uranium without enrichment mainly because heavy water:

UPSC-style question 4

With reference to fissile materials, consider the following statements:

  1. Plutonium-239 and uranium-233 do not occur in nature in usable quantities and are produced in nuclear reactors.
  2. Plutonium-239 breeds fuel best in fast reactors, while uranium-233 breeds best in slow-neutron reactors.
  3. Uranium-233 fuel is easy to handle because it emits almost no radiation.

Which of the statements given above is/are correct?

Write in about 50 words

Why does India's PHWR fleet not need enriched uranium, and why has that mattered for India?

0 words
Write in about 50 words

Why do all three fissile materials attract international safeguards?

0 words

The next question A controlled chain reaction gives heat. How does a power plant turn that heat into electricity, and why are there different kinds of reactor?